top of page
Spiroid Gear Pair

Spiroid Gear Pair



A hypoid is a type of spiral bevel gear whose axis does not intersect with the axis of the meshing gear. The shape of a hypoid gear is a revolved hyperboloid (that is, the pitch surface of the hypoid gear is a hyperbolic surface), whereas the shape of a spiral bevel gear is normally conical. The hypoid gear places the pinion off-axis to the crown wheel (ring gear) which allows the pinion to be larger in diameter and have more contact area. In hypoid gear design, the pinion and gear are practically always of opposite hand, and the spiral angle of the pinion is usually larger than that of the gear. The hypoid pinion is then larger in diameter than an equivalent bevel pinion.

Hypoid Gears Are Stronger, Operate More Quietly And Can Be Used For Higher Reduction Ratios, However They Also Have Some Sliding Action Along The Teeth, Which Reduces Mechanical Efficiency, The Energy Losses Being In The Form Of Heat Produced In The Gear Surfaces And The Lubricating Fluid.

In Older Automotive Designs, Hypoid Gears Were Typically Used In Rear-Drive Automobile Drivetrains, But Modern Designs Have Tended To Substitute Spiral Bevel Gears To Increase Driving Efficiency.

Hypoid Gears Are Still Common In Larger Trucks Because They Can Transmit Higher Torque. A Higher Hypoid Offset Allows The Gear To Transmit Higher Torque. However Increasing The Hypoid Offset Results In Reduction Of Mechanical Efficiency And A Consequent Reduction In Fuel Economy. For Practical Purposes, It Is Often Impossible To Replace Low Efficiency Hypoid Gears With More Efficient Spiral Bevel Gears In Automotive Use Because The Spiral Bevel Gear Would Need A Much Larger Diameter To Transmit The Same Torque. Increasing The Size Of The Drive Axle Gear Would Require An Increase Of The Size Of The Gear Housing And A Reduction In The Ground Clearance.

Another Advantage Of Hypoid Gear Is That The Ring Gear Of The Differential And The Input Pinion Gear Are Both Hypoid. In Most Passenger Cars This Allows The Pinion To Be Offset To The Bottom Of The Crown Wheel. This Provides For Longer Tooth Contact And Allows The Shaft That Drives The Pinion To Be Lowered, Reducing The "Hump" Intrusion In The Passenger Compartment Floor. However, The Greater The Displacement Of The Input Shaft Axis From The Crown Wheel Axis, The Lower The Mechanical Efficiency.

    產品網頁: Stores_Product_Widget
    bottom of page